# About the ODrive Pro Support category

**URL:** <https://discourse.odriverobotics.com/t/about-the-odrive-pro-support-category/10586>\
**Category:** ODrive Pro Support\
**Created:** [July 6, 2023, 6:45pm UTC](https://discourse.odriverobotics.com/t/about-the-odrive-pro-support-category/10586 "2023-07-06T18:45:23Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![madcowswe](https://discourse.odriverobotics.com/user_avatar/discourse.odriverobotics.com/madcowswe/32/1138_2.png) [@madcowswe](https://discourse.odriverobotics.com/u/madcowswe)\
**Post date:** [July 6, 2023, 6:45pm UTC](https://discourse.odriverobotics.com/t/about-the-odrive-pro-support-category/10586/1 "2023-07-06T18:45:23Z")

</div>

If you need help with your ODrive Pro this is the place to get it.

---

<div class="post-metadata">

**Author:** ![gokul\_1421](https://discourse.odriverobotics.com/user_avatar/discourse.odriverobotics.com/gokul_1421/32/7112_2.png) [@gokul\_1421](https://discourse.odriverobotics.com/u/gokul_1421)\
**Post date:** [July 24, 2025, 12:50pm UTC](https://discourse.odriverobotics.com/t/about-the-odrive-pro-support-category/10586/2 "2025-07-24T12:50:03Z")

</div>

We purchased the ODrive Pro board to use with the Web GUI. Later, we discovered that the board does not support a brake resistor. According to the ODrive documentation, the ODrive Pro can operate with a battery if a brake resistor is not available.

Hi,  
We connected a 5065 270KV motor along with an AMT102 encoder. Brake resistor settings were disabled, and the DC bus voltage limit was set to 50V. The battery voltage was 56.5V. However, after loading the configuration, we received a “DC bus over-voltage” error.

We would prefer not to purchase a regen clamp. What is the recommended way to test the motor in this setup?  
how should i config the parameters to make it work.