ODrive Community

Topic	Replies	Views	Activity
Development board pre-installed	4	1021	March 23, 2020
Closed Loop violent vibrations Support	4	1854	March 20, 2020
Leather sewing machine, hoverboard hub motor. Low speed high torque? Projects	2	1663	March 20, 2020
Odrive v3.6 current surge affecting USB? Support	1	930	March 20, 2020
Set the first position Support	2	1381	March 20, 2020
Velocity using step/dir possible?	6	1479	March 17, 2020
use stm32 with odrive Support	1	1333	March 17, 2020
Error_motor_disarmed & error_control_deadline_missed Support	3	3631	March 17, 2020
Stall Torque and Bus Voltage	2	1629	March 17, 2020
Motor move to position issue Support	9	3288	March 17, 2020
Continuous current limit	1	933	March 17, 2020
Motors getting really hot during motor and encoder offset calibration Support	1	1331	March 17, 2020
Choppy operation with D5065 motor	1	1098	March 17, 2020
Missing controller command move_to_pos	2	1516	March 17, 2020
ODrive Broken after Soldering	1	985	March 17, 2020
Odrive Controller powers down motor after short amounts of use Support	1	689	March 17, 2020
Problem with AXIS_STATE_MOTOR_CALIBRATION and Hoverbord Motor Support	2	3206	March 16, 2020
Motor recommendations for ~28-32mm diameter? Support	0	703	March 16, 2020
Using a lower voltage motor with a higher voltage supply Support	1	1053	March 16, 2020
ROS node for Odrive	3	6245	March 16, 2020
Odrive with 72V 84V input voltage	3	1206	March 16, 2020
Need help setting up hoverboard motors Support	3	2768	March 15, 2020
USB C++ Inteface for Odrive 3.6 with Native Protocol	0	948	March 13, 2020
Using 2nd Encoder to set pos_estimate_ Projects	4	2201	March 13, 2020
Can not connect to ODrives, or flash new firmware Support	9	4285	March 11, 2020
Connecting issue in latest kubuntu Support	3	1070	March 11, 2020
Arduino Closed-Loop Current Control Issues Support	2	2729	March 9, 2020
Encode 5047p connection	6	2750	March 9, 2020
How current control work? Support	5	2408	March 8, 2020
Question about torque calculation	4	2927	March 6, 2020